Central Heating Installation

Central Heating Installation is critical to ensure that your home or workplace is perfectly warm. One can conduct such Central Heating Installation as a DIY, but it is recommended that an expert contractor carry out the Central Heating Installation.

Central Heating Installation is dependant on each place's structural patterns and is unique to each structure. However one can generally classify this in few types.

The Conventional Central Heating Installation requires two tanks, one - cold water storage and the other feed tank and also a hot water cylinder. This system requires large space for storage so requires prior thinking in installation.
System Boiler Central Heating Installation requires a storage tank too but most of the components are inbuilt and hence installation is cheaper and quicker. Thus a sealed system including a pressure relief valve and a pressure gauge removes the need for a feed and expansion tank.
Combination Boiler Central Heating Installation does not require tanks as it runs on mains pressure water. It also eliminates the need for a hot water cylinder as it instantly heats the water when it is needed. It also requires the least amount of plumbing thus offering a cost saving when installing.

Heating System

A water central heating system consists of basically the boiler, the radiators and the interconnecting piping. The piping is generally installed below the radiator. Where the piping is above the radiators there must be bleed valves to allow any air in the system to be released. The piping can be below the floor or in the ceiling. In wooden floors it can be concealed below floorboards with risers connecting out of holes to radiators. The piping can go along the joist or across it through cut outs. It should not support the weight of the floor as it would increase chances of breakage. In suspended ceilings piping is normally installed between the joists of the ceiling from above. One can also run the feed pipes around the top of the wall just below the ceiling with fall pipes. The piping should be insulated as it is safer and also there is energy conservation. Measuring heat loss of a room will help conserve energy as well.

Some aspects one must not forget in central heating installation are:

1) Air temperature at feet level, not greater than 3 degrees C below that at head level.
2) Airflow past the body is horizontal and at variable velocity.
3) Room surface temperatures not above the air temperatures.
4) Relative humidity between 40% to 60%.
5) Adequate temperature control methods.
6) Safety procedures.
7) Cost-effective longevity.

During central heating installation one must identify what is best suited for your purposes, needs and pocket. It should not be a burden or over time reduce the value of your property. Central heating installation is best when a balance between installation cost and optimum usage is obtained.

Related Articles